From Lightform Creator, publish your project to your drive by using the "Publish to Local Folder" option. This produces a zip file at the location you specify, and you'll need it below when publishing from the command line.
Download cURL: https://curl.se/windows/dl-7.79.0_1/curl-7.79.0_1-win64-mingw.zip and extract the zip file to your drive.
Open a command prompt, and cd to the bin folder within the extracted cURL zip folder. For example, if you extracted it to your user's download folder, you would use something like (replace with your username):
cd C:\\\\Users\\\\<username>\\\\Downloads\\\\curl-7.79.0-win64-mingw\\\\bin
You should see the curl.exe program in the bin folder.
Run the following command to publish to your device:
curl.exe -v -H "Expect:" -H "Content-Type: application/lightform+zip" --data-binary "@<path\\\\to\\\\file>" <device-ip>:7346
In the above command, you need to replace <path\\\\to\\\\file> with the full path to the published zip file generated in step 1 (important: make sure to put an "@" in front of the path), and replace <device-ip> with the IP address of your device (visible on the Control Page in Creator, or on the device's testcard). Here's a full example:
curl.exe -v -H "Expect:" -H "Content-Type: application/lightform+zip" --data-binary "@C:\\\\Users\\\\kevin\\\\Downloads\\\\New Project-Published\\\\New Project-Published.zip" 192.168.1.14:7346
Finally, you must tell the device to play the project with the following curl command (make sure to use your device's IP):
curl.exe -v -d "play" <device-ip>:7341/control/playback/state
You can also stop the project with the following:
curl.exe -v -d "stop" <device-ip>:7341/control/playback/state
On LF2/LF2+, you can also control the projector's light engine with the following commands:
curl.exe -v -d "on" <device-ip>:7341/control/projector
curl.exe -v -d "off" <device-ip>:7341/control/projector
To do a hard reboot of the device, you can use the following command:
curl.exe -v -d "" <device-ip>:7341/control/reboot